Loading... Please wait...
  • Image 1

PAXTON ACCESS 325-030-US RJ45 READER PORT CONNECTOR 2 PACK

Price:
$76.48
SKU:
325-030-US
Shipping:
Calculated at checkout
Quantity:

Product Description

RJ45 READER PORT CONNECTOR 2 PACK

Installer tools          


  • A range of low cost tools to
  • Designed to speed up installation
  • Module to prevent damage from lightning strikes
  • Can be ordered direct from Paxton Access
 
 
About - A range of products designed to assist installers to specify and install Paxton Access equipment.
Reader junction box: This module can be used to provide a connection point for the reader's RJ45 plug.
RJ45 reader port connector: This module is used to convert the standard reader ports on Switch2 and Net2 controllers to accept 1 or 2 RJ45 connections.
RS485 protection module: Under severe electrical storm conditions, the Net2 ACU's connected to the RS485 data line can be damaged.  This module is designed to stop the passage of high voltage along the data line.
Hands free read range tester: This tool enables the measurement of token wake up range from hands free enabled readers. This allows the optimum placement of readers on installation.
RS485 IDC connection module:The module has been designed to speed up the installation of a Net2 controller with a Cat5 data line.  It converts the standard screw terminal Net2 Network connection into Krone terminal strips. Installation - Reader junction box: The terminals on the module are wired color for color to the controller.
RJ45 reader port connector:  Pull off the screw termanal block from the reader port on the ACU and replace it with this module.
RS485 protection module: Fitted at either end of any vulnerable cabling run to isolate the section.
RS485 IDC connection module: A Krone insertion tool (not supplied) should be used to ensure a good connection of the wires into the terminal strip.
Hands free read range tester No installation required.